ATAGS Customization Form

Waist Modification Instructions

Attention: Only unused suits are eligible for alterations.

To obtain the measurement for the waist modification please follow the steps below. Then fill out the form below.

Step 1

Put the ATAGS trouser on and adjust all lacing panels. - Once all lacing panels are adjusted, inflate the bladder.

Step 2

While inflated, pinch the waist band to the desired tightness and measure the fold in inches.

Step 3

Multiply the measurement of the fold by 2 then enter that result in the ‘Measurement of Fold × 2 (in.)’ form field below, after selecting a suit size. (all reductions to be in increments of ¼”)

Step 4

Locate the Serial Number and Lot Number inside the suit, then enter them in the form below.

Fill out the form below, by selecting a suit size, and entering the suit information.

Select Suit Size

Measurement of Fold × 2 (in.) (See steps 1-3 above to get this number)

Must be between 1 1/2” - 4” and in increments of ¼”. Note: If your measurement result exceeds this, then try on a smaller size and repeat steps above. If your measurement result is smaller, then try on a larger size and repeat steps above.

Suit Information

Serial Number (Can be found on back label - See Example)

Lot Number (Can be found on back label - See Example)

Suit Information

Serial Number (Can be found on back label - See Example)

Lot Number (Can be found on back label - See Example)